Operation
21
Risk of fire with overheated food.
Unattended food can overheat and
catch alight.
Do not leave the Tepan Yaki unatten-
ded whilst it is being used.
Please note that the heating-up time
is very rapid with induction heating.
Switching on the Tepan Yaki
Touch the
sensor control.
Further sensor controls will light up. If
no further entry is made, the Tepan Yaki
will switch itself off after a few seconds
for safety reasons.
Setting the power level
Touch the appropriate sensor control
on the respective numerical keybank
for the power level you want.
Switching off
To switch off a Tepan zone, touch the
0
sensor control on the numerical
keybank for that zone.
To switch off the Tepan Yaki and both
zones, touch the
sensor control.
Residual heat indicator
If the SmartLine element is still hot, the
residual heat indicator will light up after
it has been switched off. Depending on
the temperature, a dot will appear
above power levels 1, 2 and 3.
The dots of the residual heat indicator
go out one after the other as the Smart-
Line element cools down. The last dot
only goes out when the SmartLine ele-
ment is safe to touch.
Danger of burning due to hot
surfaces.
The surfaces will be hot after cook-
ing.
Do not touch the surfaces while the
residual heat indicators are on.
Summary of Contents for SmartLine CS 7632
Page 49: ...Building in dimensions 49 Onset installation a Front b Mains connection cable L 2000 mm ...
Page 64: ......
Page 65: ......
Page 66: ......