![background image](http://html.mh-extra.com/html/miele/t300/t300_technical-information_235249044.webp)
Technical Information
T300 Series Clothes Dryer (Condenser)
5.14
Rear Drum Seal
5.14.1
Replacement
1. Proceed as in Section 5.13.1 – Drum Removal.
2. Fit the new seal so that the felt faces towards the rear of the appliance
and the rubber groove for the clamp ring faces the front. The drum is
sealed axially.
5.15
Front Drum Seal
5.15.1
Replacement
1. Open the front panel – Refer to Section 5.2.1.
2. Remove the fill ring/exhaust vent duct (refer to Section 5.6.1 – Fan
Unit Removal - Machine Nos. without Prefix, Steps 2-5 or Section
5.6.2 – Fan Unit Removal – Machine Nos. with Prefix, Steps 2 and 3).
3. Remove the bearing ring (Refer to Section 5.12.1 – Drum Drive Belt
Replacement, Steps 4, 6 and 12).
5.16
Bearing Shells
5.16.1
Replacement
1. Unscrew the drum rear panel (Refer to Section 5.6.1 – Fan Unit
Removal - Machine Nos. without Prefix, Steps 1-3).
2. Lever off the upper section of the bearing shell with a screwdriver and
remove the bearing.
3. Grease the new bearing shells and fit onto the ball pin. (A 6gm grease
sachet with “Unisilicone TK 572 6 G”, Part no. 2338790, is supplied
with the bearing shell).
Note:
Assemble the rear drum panel as described by the
Note
in Section 5.4.1
– Heater Bank Removal (Machine Nos. without a Prefix).
44