What to do, if . . .
Cause . . .
Remedy . . .
. . . the "Check inlet" indica-
tor flashes during the
programme but the
programme is running nor-
mally.
The water inlet is restricted.
–
The stopcock is not opened
far enough.
–
The inlet hose is kinked.
–
The water pressure is too low
–
The filter in the inlet hose is
dirty. Clean it.
. . . the "Check inlet" indica-
tor flashes and the laundry
was not washed.
The water inlet is closed.
–
Open the stopcock.
–
Start the programme again.
. . . one of the following indi-
cator lights is flashing
-
"Soak/Pre-wash"
-
"Main Wash"
-
"Rinses"
-
"Rinse hold"
There is a fault.
–
Press "I-ON/0-OFF" button to
release it.
–
Turn the programme selector
to "Finish".
–
Press "I-ON/0-OFF" button in.
–
Re-start the programme.
–
If the indicator light starts
flashing again, call the Ser-
vice Dept.
Problem solving guide
47