Connection to the drainage system
The machine drains via a drain pump
with a delivery head of 1 metre.
The drain hose is 1.5 m long. It must
not be kinked as this restricts drainage.
The swivel elbow at the end of the hose
can be turned in either direction, or can
be detached if required with a sharp
twist and pull.
Drain hose connection:
Direct into a sink: Hook the hose
over the edge and secure. Make
sure that the water can flow freely to
avoid flooding and to prevent water
from being sucked back into the ma-
chine.
Connected to a standpipe.
Connected to a plastic drain pipe
with a rubber nipple. There is no
need to use a non-return valve.
Allow the water to drain off into a
floor drain.
If required, the hose can be extended
to a length of 5 m. The necessary parts
can be purchased from the Miele
Spare Parts department.
For a delivery head of more than 1 m
(up to a maximum of 1.8 m) a second
Duo drain pump is available with the
corresponding conversion kit from the
Miele Spare Parts Department.
Plumbing
39
