Before using for the first time
22
5. Commissioning TwinDos
Skip
Continue
Set up TwinDos?
Touch the
Continue
sensor button to
set TwinDos up straight away.
Useful tip:
To postpone setup until
later: touch the
Skip
sensor button. The
following message will then appear in
the display:
It is possible to set up later in “Settings /
TwinDos”.
Confirm with the
OK
sensor button.
Determining the water hardness
Water hardness is an indication of the
amount of minerals dissolved in water.
The more minerals in the water, the
higher the water hardness and more
detergent must be dispensed.
Useful tip:
You can measure the water
hardness yourself using the enclosed
test strip. Alternatively, your local water
authority will be able to tell you the
hardness of water in your area.
Dip the test strip in the water for
approx. 1 second. Shake excess
water off the test strip.
After approx. 1 minute, and based on
the coloration, you will be able to read
the water hardness from the table
below.
Test strip
Hardness range
4 green areas
Hardness level I
1 red area
2 red areas
Hardness level II
3 red areas
Hardness level III
4 red areas
Settings for compartment
The procedure for Miele UltraPhase 1
and Miele UltraPhase 2 is described
below.
No agent
Agent for comp.
Miele
UltraPhase 1
OK
11:02
Touch the
Miele UltraPhase 1
sensor
button.
The following message will then appear
in the display:
Please enter the dosing recommendation
of your detergent for a wash with normal
soiling. Note your water hardness level.
The dispensing quantity for
UltraPhase 1 for
(hardness range
I)
is pre-set.
