Frequently Asked Questions
Fault message after a program has been interrupted
Problem
Possible cause and solution
Drainage fault. Clean
drain filter and pump.
Check the drain
hose.
The drain is blocked or restricted.
The drain hose has been fixed too high.
Clean the filter and the pump.
The maximum drain height is 1.0 m.
Water intake fault.
Open the water
supply.
The water inlet is blocked or restricted.
Check whether the faucet is turned on properly.
Check whether the inlet hose is kinked.
Check whether there is sufficient water pressure.
The filter in the water inlet is blocked.
Clean the filter.
Fault F. If restart
fails, call Service.
There is a fault.
Disconnect the washing machine from the
electrical supply. Unplug the appliance or switch
off the circuit breaker.
Wait
at least 2 minutes
before reconnecting the
washing machine to the electrical supply.
Then switch the washing machine on again.
Restart the program.
If the error message appears again, contact Miele
Service.
Waterproof system
activated. Close
water supply and
contact Service.
The water protection system has reacted.
Close the faucet.
Contact the Service department.
To switch off the fault message: switch the washing machine off with the
button.
70