Wireless DA-073 Heavy Duty Outlet with DA-606 Timer
The
DA-073 Heavy Duty Outlet
must work in conjunction with a
DA-606 Remote Control
Transmitter
.
Both units are pictured at right.
Follow the steps below to prgram the DA-073 with the DA-606
(see
Figure A
):
1. Plug a load, such as a lamp, into the
DA-073 Heavy Duty Outlet
2. Plug the DA-073 into a 115 VAC Outlet. The RED LED will flash once and the Load should be off.
3. Press and hold the SET button for about 3 seconds, the RED LED will begin to flash. Continue to
hold the SET button until the RED LED stays on steady. Then, release the SET button.
4. Press the small RED button on the back of the
DA-606 Remote Control Transmitter
for 1 second,
and then the front button for 3 seconds. The RED LED on the DA-073 Outlet will flash quickly
and then stop.
5. Press the front button on the DA-606 again. The load should come on and be in the 1 minute
timing mode.
The DA-073 will now be controlled by the DA-606 Remote Control Unit. You may change the Load
Time Duration, or cycle time, of the DA-073 by following these steps:
1. Press the front button on the DA-606 so the load is on
2. Press the SET button on the DA-073 until the RED LED flashes the number shown below for the
Load ON Time Duration you would like:
1 flash
= 1 minute
2 flashes
= 5 minutes
3 flashes
= 15 minutes
4 flashes
= 30 minutes
5 flashes
= 60 minutes
If you wish to change the Load ON Time Duration, cycle time, again go back to step 1
To erase all programming the DA-073
:
1. First remove power to any other DA-073, DA-071, or DA-072 accessories you may have.
2. Erasing programming will erase all Mier Wireless Accessories that are powered on.
3. Remove power to the DA-073 by unplugging it from the 115 VAC outlet.
4. Press and hold the SET button while plugging the DA-073 into the 115 VAC outlet. The
RED LED will be on first, then flash rapidly, then on, then off. Release the SET button.
Programming should now be erased.
DA-073 Specifications:
Input Voltage:
115 VAC, 60Hz
Minimum Load:
10 Watts
Maximum Rating:
1500 Watss at 115 VAC
Operating Frequency:
315 MHz
Range:
up to 500 feet in open area
FCC: This device is approved by the FCC and it complies with Part15 of the FCC Rules. It’s op-
eration is subject to the following conditions:
• This device may not cause harmful interference
• This device must accept any interference that may cause undesired operation
DA-073
Wireless Outlet
DA606
Remote Control
Transmitter
1
800-473-0213 | info@mierproducts.com | www.mierproducts.com
2
3
RED LED
LED Flashing: ON/OFF Mode
LED Steady ON: Timer Mode
Figure A
Bottom of
DA-073
