Wireless DA-606LK and DA-606LK2 Light Kits
The
DA-606LK Light Kit
includes a DA-606 Remote Control Transmitter, DA-071
Wall Light Switch Receiver, and a DA-072 Lamp Module Receiver (pictured at right).
The
DA-606LK2 Light Kit
includes a DA-606 Remote Control Transmitter,
DA-071 Wall Light Switch Receiver, but DOES NOT include a DA-072 Lamp Module.
These parts easily hook up to a DA-600 Wireless Drive-Alert or a DA-605 Wireless
Drive-Alert.
However, if using a DA-500 Buried Sensor Drive-Alert you must also
order the additional DA-500LKA Light Kit Adapter (see below and next page).
The
DA-073 Heavy Duty Outlet
is an
optional
accessory.
The DA-071 Wall Switch can replace an existing light switch, and the DA-072 Lamp
Module can be used in any outlet to turn on a lamp plugged into the DA-072. The
DA-071, DA-072, and DA-073 are designed for 120 VAC (see load specs on page 4).
All of the components in our Light Kits are FACTORY PROGRAMMED and set to operate as a matched set. If other devices
are purchased later, the DA-606 Remote Control Transmitter will need to be programmed to operate these units. Programming
instructions are provided at the end of this manual. Erasing the factory programming from any unit is also explained.
The DA-606 Remote Control is triggered by a relay closure in a Drive-Alert control panel. This timer control can be set from 1 to
60 minutes. When triggered, the DA-606 transmits a UHF (318 MHZ) coded radio signal to activate the installed DA-071, DA-072,
and or DA-073 devices for the specific time interval that was set. After the preset time interval, the devices will turn off.
The signal path from the DA-606 to any DA-071, DA-072, and DA-073 devices must be unobstructed by metal objects such as
large appliances, or mirrors. Metal objects/mirrors in the signal path may block the activating signals. If the devices are not
working when a Drive-Alert detects a vehicle, in most cases the problem will be solved by moving the DA-606, and/or the devices,
so there is a clear signal path. Use the “TEST” push-button on the DA-606 to verify operation.
For FREE Technical Support contact Mier Products!
DA-606LK
Wireless Light Kit
The DA-606LK includes:
• one DA-606 Remote Control
• one DA-071 Light Switch with Cover
• one DA-072 Lamp Module
800-473-0213 | info@mierproducts.com | www.mierproducts.com
Individual Accessories
DA-606
Remote Control
Transmitter
DA-071
Wireless
Light Switch with Cover
DA-072
Wireless
Lamp Module
DA-073
Wireless
Heavy-Duty Outlet
DA-500LKA
Light Kit Adapter
For DA-500 Drive-Alert
