Operators Manual
33
36
85001034
Secondary rectifier heat sink
1
37
85001035
Fast recovery diode
2
38
85001036
Secondary rectifier heat sink
39
85001037
Secondary rectifier inverter board
1
40
85001038
Resistance 2
1
85001039
Resistance 1
1
41
85001040
Gun switch isolation plate
1
42
85001041
Board fixed plate
1
43
85001042
Bracket for current filter
1
44
85001043
Main PCB control card
1
45
85001044
EMI filter
1
46
85001045
Body panel
1
Maintenance, Transportation and Storage
The welder needs regular maintenance as following: Periodically clean dust, dirt, grease,
etc. from your welder. Every six months, or as necessary, remove the cover panel from the
welder and air-blow any dust and dirt that may have accumulated inside the welder. Replace
power cord, ground cable, ground clamp, or electrode assembly when damaged or worn.
Minor and Routine Maintenance
Store in a clean dry facility free from corrosive gas, excess dust and high humidity.
Temperature range from 10F120°F and the relative humidity not more than 90%.
When transporting or storing the welder after use, it is recommended to repack the product
as it was received for protection. (Cleaning is required before storage and you must seal the
plastic bag in the box for storage.
Hazard Warnings
