1
2
3
4
5
Torque Tube assembly
Carbon tail rotor push rod
Bag 8 + 12
10 mm Shrink tubing
10 mm Shrink tubing
10 mm Shrink tubing
10 mm Shrink tubing
Push the four ball bearing mounted plastic sleeves to the torque tube, use the 10 mm adhesive shrink tubing to hold the bearings in position.
Please ensure prior to inserting the torque tube that the tail boom is dirt-free
inside. If necessary clean it with a cloth.
Please apply a good amount of grease to the rubber o-rings and to the inside of
the tail boom before inserting the torque tube assembly into the tail boom.
Apply grease to the o-rings.
Sand the carbon
tube before glueing
the ball link adapters
in place.
Chassi
Shrink tubing
Manual LOGO 700 - ©Mikado Model Helicopters GmbH - Page 11
6 Torque Tube
230mm
210mm
140mm
100mm
60mm
5 min Epoxy
5 min Epoxy
60 mm
39 mm
2x
2x
2x
2x
M3
M3x16
3mm
M3x16
