Bag 10
Please apply grease here
Larger inner Ø
Smaller inner Ø
Please apply grease to the O-rings
and to the inner surface of the yoke.
Only tighten and
secure these screws
after adjusting the
rotor head links.
Only finally tighten and
secure after mounting
the rotor head to the
main shaft.
Head Dampeners for 3D Flying
This kit comes standard with 6 x 80 shore dampers which is our “Medium Dampener Configuration”. The medium dampers are great
for smoother flying at all RPMs. You can use the Medium Dampers for Sport to gentle 3D flying at all RPM ranges. However, if you
fly aggressive 3D maneuvers with the medium damper set installed it will increase your chance of boom striking the model!!!
If you want to perform aggressive 3D maneuvers you ***MUST*** change out the outer dampener on each
side from a 80 shore dampener, to one of the 2 x 90 shore dampeners which are included.
This is the “Hard Damper Configuration” and dampers will go
90-80-80 — 80-80-90
Installing the 2 x Hard Dampers will make the model more suitable for aggressive 3D flying but may induce wobbles at certain RPM ranges.
Do not try to put more then 2 x 90 dampers in the head as this will over compress the head and can damage the thrust bearings.
However due to the size of the model, even with the Hard-Damper Configuration, not all type of aggressive
maneuvers can still be performed. Please refer to the section on how to fly the model on page 2
Only tighten and secure
these screws after adjusting
the rotor head links.
Use the stock washer from
the rotor blade box..
Manual LOGO 800 - ©Mikado Model Helicopters GmbH - Page 15
10 Rotor Head
4x
M3x12
2x
M3x16
Kugel/ball Ø6
2x
3x5x0,5
2x
6x12x1,5
10x20x6,5
2x
2x
1x
M3x6
2x
2x
2x
M3x25
M6x12
M5x30
2x
M5
M3x25
M3x12
M3x16
5x24x1
M5x30,
M3x6
3x5x0,5
M6x12
6x12X1,5
M4x25
1x
M4x25
5x24x2
