Mikasa MT-76D, Instruction Manual

Precautions before starting work(Continued)

DANGER

！

If the machine falls over while working, the machine will move forward due to the kicking 

motion of the foot while it is lying on its side. If the ground is solid, it will move quickly and is 

very dangerous. To ensure that the operator and anyone nearby are safe, turn the throttle 

lever to the engine stop position and make sure the machine stops. You must be extremely 

careful when working on a road because a serious accident can easily occur.

Before lifting the machine, make sure  that there is no damage to any of the components on 

the machine (look especially for damage to the rubber dampers and the hook). There must 

not be any loose or missing screws and the machine must generally be in a safe condition.

Turn the engine off before lifting the machine.

Use wire cables with enough strength to support the machine.

DO NOT

 lift it higher than necessary, for safety.

DO NOT

use a damaged wire cable.

Never lift or lower the machine rapidly when using a hydraulic shovel or a crane.

When lifting the machine, do not allow any people or animals to pass under or near the 

machine.

When using any type of equipment to lift the machine, be careful that the lifting equipment 

does not cause an accident. Make sure you check the lifting equipment carefully, to ensure 

that there are no problems or damage.

Take the utmost care not to allow the 

machine to fall during work, or when 

stopped or stored. Secure the 

machine with a rope or similar tie 

when stored or left idle so that it 

cannot fall. If the rammer falls over 

when children are around, a serious 

accident may occur. If the machine 

foot is worn, the machine will be 

especially unstable. If the machine 

foot is worn badly, replace it with a 

new one.

Only use the single hook to lift the 

machine. 

DO NOT

 support it from any 

other points (such as the handle).

■

■

■

■

■

■

■

■

■

■

■

Precautions while lifting

DANGER

！

4