2.3 Target connector
On the bottom of the CODEGRIP device there is the sticker which contains
additional information.
∫
Supported MCU family/architecture
∫
Unique serial number
∫
Unique WiFi MAC address
DATA
VCC-TGT
DATA
GND
DATA
GND
DATA
DATA
DATA
PROG MUX/GND
DATA
GND
DATA
GND
DATA
GND
DATA
GND
DATA
GND
The CODEGRIP device is equipped with the connector used to interface
the device with the target MCU. The connector allows it to perform
programming and debugging operations, to provide the power supply for
the target MCU, and to be used as the power input when the CODEGRIP
device is powered from the connected development board. More detailed
descriptions of connector pinout for every supported architecture can be
found futher in this document.
N O T E
When the connected host board provides power to the CODEGRIP
device, CODEGRIP input voltage must be in range 2.5V to 10V.
Summary of Contents for CODEGRIP UNIVERSAL
Page 4: ......
Page 14: ...C O D E GRIP...
Page 17: ......
Page 29: ...Dark or Light it s your choice...
