29
MikroScan 7600PRO
Operator’s Manual
Catalog 11180-94
V15.4F 050406
Section
Getting Started
3.1 Charging the Batteries
Your MkroScan 7600PRO was suppled wth two Lthum Ion (L-on) Batteres. When
fully charged, each battery should provide approximately 110 minutes of continuous
operatng use. Because these batteres have been shpped from the Mkron Factory wth
a minimal charge, they will need to be fully charged before use.
Step 1
Step 2
Step 3
Step 4
1) Plug the battery charger power cord into a standard wall outlet.
2) Position one battery pack on the battery charger by aligning the
brackets and terminal ports on the battery pack to those on the
charger.
3) Press down on the battery pack while sliding it forward into
position.
4) Repeat steps 2 and 3 for the second battery pack.
Chargng tme s approxmately 100 mnutes per battery.
NOTE:
• Store battery packs
in a cool, dark loca-
tion when not in use.
• Recharge the battery
pack every 6 months
when in storage.
Also recharge before
and after every use.
NOTE:
• Store battery packs
in a cool, dark loca-
tion when not in use.
• Recharge the battery
pack every 6 months
when in storage.
Also recharge before
and after every use.
NOTE:
If the charger has been
connected to the power
supply before placing
the battery packs into
position, the charging
pattern will not be posi-
tion dependent. That
is, the first battery to
be inserted will begin
charging regardless of
the position it holds.
Once that battery is
fully charged, the sec-
ond battery will begin
charging.
NOTE:
If the charger has been
connected to the power
supply before placing
the battery packs into
position, the charging
pattern will not be posi-
tion dependent. That
is, the first battery to
be inserted will begin
charging regardless of
the position it holds.
Once that battery is
fully charged, the sec-
ond battery will begin
charging.
3
Summary of Contents for 7600PRO
Page 2: ......
