Section 3
Getting Started
30
MikroScan 7600PRO
Operator’s Manual
Catalog 11180-94
V15.4F 050406
3.1 Charging the Batteries (continued)
The battery charger has one red “Power On” lamp and two green “Charging” lamps.
The charging indicator lights indicate the charger assembly status as listed below:
Color
Status
Notes
Green, Flashing Charging
Flashes green ‘on’ and ‘off’
at 1 Hz whle n the chargng
mode.
Green
Full Charge Indicator light will remain
green once the battery pack
has been fully charged.
Black
Error
Chargng lghts wll turn off
f an error has been detected.
Power Lamp
Chargng Lamp 1
Chargng Lamp 2
3.2 Connecting the Power Supply
Although there are several optonal power supply accessores avalable for your
MikroScan 7600PRO, the standard power supply options supplied with your camera
nclude the AC Adapter and two battery packs. Ths secton wll cover the steps neces-
sary for usng these standard power supply optons.
3.2.1 Before You Begin
Before applying any power source to your MikroScan 7600PRO, it is important that the
power swtch on the camera be n the off poston.
O = off position
I = on position
Step 1
Step 2
1) Open the hatch cover on the back of the camera.
2) Verify that power switch is in the off position as indicated in the
figure above.
NOTE:
If the battery
temperature is lower
than -10°C ±3°C or
higher than 60°C ±3°C,
the charger goes into a
standby mode and the
charging lamps will
continue to flash green
for 120 minutes. After
120 minutes, the charg-
ing lights turn off.
NOTE:
If the battery
temperature is lower
than -10°C ±3°C or
higher than 60°C ±3°C,
the charger goes into a
standby mode and the
charging lamps will
continue to flash green
for 120 minutes. After
120 minutes, the charg-
ing lights turn off.
Summary of Contents for 7600PRO
Page 2: ......
