RouterBOARD 200 Series User's Manual
J11
5V 400mA (2W) Fan output (male header)
1 GND
2 VCC +5V
3 Fan speed control
J12
Power header (positive contact is a square ( ) contact with a small '+' sign near it)
◘
J13
Power jack (positive contact is the central pin)
J14
Low Pin Count (LPC) connector
1 VCC +3.3V
2 PCICLK
3 GND
4 LFRAME
5 LPC_ROM
6 LAD3
7 LAD2
8 LAD1
9 LAD0
10 RESETX
J15
MiniPCI Type IIIA connector
J16
Intrusion Detection jumper
J17
MiniUPS daugterboard female header (proprietary pinout)
1,2 +5V DC 0.8A output; or power input for the board, +5V ±5% DC
3,4 Ground
5 Ext. power state (0 – no power, 3.8V – power ok), connected to GPWIO0 CPU signal
6 Battery low signal, associated with GPWIO1 CPU signal
7 UPS control, read from JP6 (0 – 2-3 position; 1 – 1-2 position)
8 External RouterBOARD power switch (set in “1” to switch the board off)
J18
3.3V output (positive pin is marked with a small '+' sign)
J19
GPIO header
1 VCC +3.3V
2 GND
3 SDA1 (ACCESS.bus Port 1 Serial Data Line)
4 SCL1 (ACCESS.bus Port 1 Serial Clock Line)
5 GPIO 47
6 GPIO 41
7 GPIO 40
8 GPIO 38
9 GPIO 20
10 GPIO 18
17
