See www.routerboard.com for more information. Contact support@mikrotik.com for support questions.
rev. A (6-May-2011)
Copyright and Warranty Information
Copyright and Trademarks
. Copyright MikroTikls SIA. This manual contains information protected by copyright law. No part
of it may be reproduced or transmitted in any form without prior written permission from the copyright holder. Router-
BOARD, RouterOS, RouterBOOT and MikroTik are trademarks of MikroTikls SIA. All trademarks and registered trademarks
appearing in this manual are the property of their respective holders.
Hardware
. MikroTikls SIA warrants all RouterBOARD series equipment for the term of one year from the shipping date to be
free of defects in materials and workmanship under normal use and service, except in case of damage caused by mechanical,
electrical or other accidental or intended damages caused by improper use or due to wind, rain, fire or other acts of nature.
If you have purchased your product from a MikroTik Reseller, please contact the Reseller company regarding all warranty and
repair issues, the following instructions apply
ONLY
if you purchased your equipment directly from MikroTik Latvia. To return
failed unit or units to MikroTikls you must perform the following RMA (Return Material Authorization) procedure. Follow the
instructions below to save time, efforts, avoid costs, and improve the speed of the RMA process. Take into account that all
goods have one year warranty. Instructions are located on our webpage here:
http://rma.mikrotik.com
Manual
. This a ual is pro ided as is ithout a arra t of a ki d, e pressed or i plied, i ludi g, ut ot li ited to,
the implied warranty of merchantability and fitness for a particular purpose. The manufacturer has made every effort to en-
sure the accuracy of the contents of this manual, however, it is possible that it may contain technical inaccuracies, typo-
graphical or other errors. No liability is assumed for any inaccuracy found in this publication, nor for direct or indirect, inci-
dental, consequential or other damages that may result from such an inaccuracy, including, but not limited to, loss of data or
profits. Please report any inaccuracies found to support@mikrotik.com
Federal Communication Commission Interference Statement (FCC ID: TV7RB711UA-2HND)
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution:
Any changes or modifications not expressly approved by the party responsi
le for o plia e ould oid the user’s authorit
to operate this equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation. This device and its antenna must not be co-located or operation in conjunction with any other antenna or
transmitter.
IMPORTANT: Exposure to Radio Frequency Radiation.
20 cm minimum distance has to be maintained between the antenna and the occu-
pational user and 45 cm to general public. Under such configuration, the FCC radiation exposure limits set forth for a popula-
tion/uncontrolled environment can be satisfied.
List of approved antennas:
Omni Directional (pole), WLO-2450-15, 15 dBi; Omni Direc-
tional (hor. polarization) HP, ODH 24-13, 13 dBi; Panel, WLP-2450-20, 20 dBi; Sector, SA 24-90-17-WB, 17 dBi ; Dish, DC 24-HD-PFIP, 24 dBi
Antenna Installation.
WARNING: It is installer's responsibility to ensure that when using the authorized antennas in the Unit-
ed States (or where FCC rules apply); only those antennas certified with the product are used. The use of any antenna other
than those certified with the product is expressly forbidden in accordance to FCC rules CFR47 part 15.204. The installer
should configure the output power level of antennas, according to country regulations and per antenna type. Professional
installation is required of equipment with connectors to ensure compliance with health and safety issues.
