INDU WRC-2010H Controller – User’s Manual
ver. 1.07
- 11-
29.05.2008
4.5. Editing of parameters set during controller operation
It is possible to correct previously set parameters while the controller executes a program. Follow the procedure
below (during program execution) to do that:
-
press “Configuration” key
-
using arrows
“up” - “down”, select parameter that you wish to change (selected parameter blinks)
-
enter the new value using numeric keys
1
4
7
0
2
5
8
3
6
9
-
and confirm with “Enter” key
-
if it is necessary, modify next parameters
-
press “Start” key
after having introduced all changes
ATTENTION !!!
Alterations introduced during controller operation are valid only until the end of manufacturing
process. After closing the program, the controller “remembers” program with data set during the
programming process.
During the program data edition the time count as well as the control of
condition of the cycle end – are stopped. The controller automatically returns to the normal mode of
operation if no key was pressed for one minute.
