The"
"icon lit up on the cleaner indicating the suction inlet is blocked or the dust
bin is full, or the garbage sensors is covered with dust.
When the cleaner is at stand by, press the"
"on the remote controller and the cleaner will
enter the FULL GO mode. (Definition of FULL GO: When choosing this function the cleaner will
automatically clean one more time after it is fully charged again. )
When the cleaner stands by, press"
"on the remote controller, and the cleaner will
enter the wall follow cleaning mode.
First install the small dustbin with the intelligent water tank (refer to page18 for the installation
method), the cleaner will automatically go to the water tank mopping mode. Press the"
"
button to start auto cleaning & mopping and the"
"will be lit up or blinking.
when the water tank runs out of water, this icon will light off, display error code E012; and
make a voice prompt"inject water , please"; if you want to continue this function during cleaning,
please take out the water tank and refill it (The default mode is standard water seeping speed. Blinking
indicates it is in fast water seeping speed, as configured in the settings by the remote controller.
See page11 for more).
To install the cleaner battery, please use a screwdriver to loosen the four screws on the
half-moon shaped bottom shell, and remove the battery installation cover (see Fig.1).
When installing the battery, please correctly connect the snap joints of the two terminals (see Fig. 2).
When not in use, place the cleaner into recharging status, which will maintain the battery in optimal
use.
If the machine is left unused for a long time, please recharge the cleaner once a month on a regular
basis to maintain the battery in optimal use.
The battery can only be replaced with the battery from the original manufacturer, otherwise it may
cause damages or accidents to the cleaner.
Panel the Robot
when
is emptied.
b
ing
