Installation, removal & cleaning of the
main brush assembly
1. Removal of the roller brush assembly:
As shown in Fig. 1, pick the U shaped clip on each side of the sweeping bracket simultaneously
with both index fingers to remove the sweeping bracket.
As shown in Fig. 2, pull up the left end of the roller brush with a hand, to take it out.
As shown in Fig. 4 ( an enlarged view of the left part ) remove the brush tube gasket on the left of
the roller brush, clean the hair off the gasket.
As shown in Fig.5 (an enlarged view of the upper left part ) remove the brush tube gasket on the
left of the roller brush, pull out the special brush strip of ONE COVER ALL to proceed with deep
cleaning or replacement (please contact your local dealer to purchase special ONE COVER ALL
brush strips for replacement )
As shown in Fig. 3, clean the hair off the brush, or wash it with water (do not replace it
until it becomes dry after washing).
