2121 Blount Road Pompano Beach, FL 33069 MileMarker.com 1.800.886.8647
PAGE 11
1.
Put on gloves and attach the strap to the hook
2.
Install the battery. Make sure the position of power
switch is at “OFF/O”. Put the battery into this product,
ensure the latch is fully engaged.
3.
Power on the winch. Turn the power switch
to the position “ON/I”. Always turn the power
switch
to
“off” when not in use.
4.
Spool out. Press the directional switch to
“
p
”, then press and hold the speed controller.
Always
keep some tension on the
rope
to
prevent bind and
entangle the
rope
, causing
damage to it and the
product. Never spool the
rope
out past the red painted
on the
rope
.
*The distance of usable rope 11.5m or
37.5 ft*
5. Secure an anchor point. Using the swiveling anchor
hook to attach the anchor point. Always make sure that
the anchor you intend to use is capable of withstanding
the load. Never hook the
rope
back onto itself. This
could damage the
rope
. A tree saver or choker chain is
recommended.
OPERATION
Take some time and practice using it before pull or lift a load, that way you will be
familiar with all the operations.
The following steps describe how to use the tool with single
rope
. A snatch block
can improve the pulling capacity.
6. Attach you
r
load. Establish a load point, use a
shackle or strap when attaching the hook to
you load. Always use a hook with a latch and
insure hook latch is secure.
7.
Give the
rope
some tension. Press the
directional
switch to “
q
”, then press and hold the
speed
controller to slowly wind the
rope
until the
rope
is
winded tightly. Never touch
rope
or hook
while
in
tension or under load.
8.
When pulling, put a
damper, blanket or other
heavy
duty material over
the
rope
.
Red paint
Stop spool out