OPERATION
9.
Plan to pull or lift. Ensure all the connections are
secured. Line up your pulling direction as straight as
possible. Side pulls can cause the
rope
to bunch at
one side of the drum,
causing damage to the rope and
the product
.
10.
Start pulling or lifting. Press the directional switch to
“
q
”, then press and hold the speed controller to wind
in the
rope
. Never exceed pulling capacity listed on
product data sheet. Double the
rope
number using a
snatch block to reduce load.
11.
Disconnect the hook from load and anchor point. Be
sure to secure the load completely. Press the
directional switch to “
p
”, then press and hold the
speed controller, release tension in the
rope
.
Disconnect the hook from the load and anchor point.
12.
Rewind
rope
. Press the directional
switch to “
q
”, then press and hold the speed
controller to slowly wind in the
rope
. Always keep
a tension on the
rope
to prevent bind and
entangle
the
rope
, causing damage to it and the
tool. Do not
let
rope
slide through your hand.
13.
Turn off the pulling tool. Make sure the position of
power switch is “OFF/O”. Store in a clean and dry
place and avoid children to contact and play.
The operation is now complete.
NOTE: Considerations for using this product
• Always take time to check the load and determine whether the load is within the specified load
range of the product.
• Always check the product for malfunction and battery status.
• Always wear gloves to prevent injury of hands caused by
rope
.
• Always pay attention to the safety of yourself and people around you.
• Practice over and over again.
Snatch Block can reduce load
2121 Blount Road Pompano Beach, FL 33069 MileMarker.com 1.800.886.8647
PAGE 12
