CONTROL BOX INSTALLATION
Mounting Control Box on Motor
1. Wrenches: 14mm, 10mm, metric Allen wrench set, pair of snips
2. General hand tools
If you choose to mount your control box on the winch motor, please follow the following steps
1. Mount the control box to mounting brackets using 10 mm wrench (Fig 2-2 & 2-3)
2. With mouting bracket attached to control box, locate the mounting points on the side of the motor die casting (Fig. 2-4)
3. With the control box placed on the motor, screw in the bolts to the mounting points (Fig. 2-5)
4. Attach the Tie Wrap around the small bracket to hold it down and clip the excess length (Fig. 2-6 & 2-7)
Fig. 2-1
Fig. 2-3
Fig. 2-2
Fig. 2-4
Fig. 2-5
Fig. 2-7
Fig. 2-6
Tools Required for Control Box Installation
NOTE:
For best results, Mile Marker recommends mounting the control box to the winch, either over the motor or over the tie bars. If you
choose to mount the control box within your vehicle, ensure that the location does not interfere with any moving or functioning parts
of your vehicle and that electrical cables with similar specifications to Mile Marker’s are used.
2121 Blount Road Pompano Beach, FL 33069 MileMarker.com 1.800.886.8647
PAGE 5
