Installation
Install 739DWK Driftwood Kit
Unpack the driftwood kit very carefully to avoid
damaging the fragile material. Install the components
as shown below. Please note that
the position of
the logs and pebbles (if used) is critical to ensure
proper performance of the appliance.
Platform
Place the platform into the fi rebox on top of the burner.
Logs
1. Identify the base log and place it in the cavity of the
ceramic platform. The protruding parts of the log
in the front should rest against the lip of the sheet
metal log support behind the burner.
2. Identify the rear log and place it on top of the base
log locating it into the notches on top of the log. Pull
the log forward so it is locked in position.
3. Place the front log inserting its two pins into the
two holes at the front of the platform. The ends of
the log should be oriented towards the front as the
log should not hang over the inside edge of the
platform.
QUALIFIED
INSTALLER
36
