2
TOP of door:
this space is
wider
TOP of door:
notch in the
rear flange
Left door panel
Installation
1. Back off both vent slide fi xing screws, locate
convection baffl e under screw heads and tighten
into place.
2. Secure the backing plate to the appliance’s outer
case from the inside as indicated (2 screws per
side).
Note: you may need to remove the side shrouds to
fi x the plate.
BOTTOM of door:
this space is
narrower
Rear view
Front view
3. Identify the left and right door panels using the
image below.
4. Identify the top and bottom of the left panel. The
notch in the rear fl ange of the panel is at the top.
The space between the rear fl ange and the edge
of the panel is wider at the top than at the bottom
of the panel as shown below.
5. Insert the top pin of the left door panel in the hole
at the top of the left shroud already installed on the
appliance.
6. Lift the panel as far as possible and insert the
bottom pin in the hole at the bottom of the shroud.
The panel should rotate freely.
7. Install the right door panel the same way.
Back off vent slide screws
Convection baffl e
