16
Servicing & Maintenance
Replacing Batteries
Low battery signal: see page 9.
The appliance uses four 1.5 V AA
alkaline
batteries for
its remote control receiver and one 9 V
alkaline
battery
for its handset. The batteries should last one to two
seasons, depending on usage. Removing the batteries
in the off -season will extend the battery life. Should the
batteries loose power, the control may be operated by
manually turning the control knob at the valve or by
turning off the valve at the switch.
To replace the batteries in the remote control
receiver
:
The receiver is located under the fi rebox, behind the
bottom cover or the fret; it sits at the left of the valve and
it is retained to the fi rebox by a
Velcro
tab.
1. Slide the bottom cover straight out from the slots
located at the bottom corners of the window frame
or unhook the fret.
CAUTION
DO NOT USE
a screwdriver or other metallic object to
remove the batteries from the receiver or the handset!
This could cause a short circuit to the receiver.
WARNING
DO NOT ATTEMPT TO CHANGE THE BATTER-
IES WHILE THE FIREPLACE IS STILL HOT!
Let
the fi replace cool fi rst before touching it.
!
2. The receiver is located to the left of the valve and it
is retained to the fi rebox by a
Velcro
tab. Grab the
receiver and pull it out from its location.
3. Slide and remove the receiver cover.
4. Replace batteries with 4 AA
alkaline
batteries.
5. Replace the cover.
6. Put the receiver back in its position pushing
it in so it attaches to the
Velcro
tab.
Using Handset Wall Holder
Your fi replace equipment includes a wall
holder to store the handset. If it hasn’t be
installed, refer to the instructions further on
in this manual for the installation.
Receiver
QUALIFIED
INSTALLER
