Zurich
Fence Letterbox
251
Contents
Your carton should contain the
following parts:
1 x Back Box
1 x Front Panel
1 x Accessories Bag
- Timber Drill Bits
- Tape Measure
- Jigsaw
- Drill
Required
Tools
www.milkcan.com.au
support@milkcan.com.au
(03) 9464 6964
56 Northgate Drive,
Thomastown VIC 3043
Back
Box
Front
Panel
The letterbox can be either mounted into a timber fence,
or built into a brick or block wall.
You will need to install
it in a location that is easily accessible to Australia Post
and couriers. The recommended height for the mail slot
is 90 to 120cm from the ground.
Choosing a Suitable Location
Timber Fence Installation
1. Measure the back box, mark and cut
a slightly larger hole into the fence
using a jigsaw.
2. Slide the back box through the front
of the fence. Screw it to the fence with
the screws provided (for hardwood
fences, it is easier to pre-drill the
screw holes).
Reach through the front parcel door
and secure the 2 x top mounting nuts.
3. Attach the front panel by inserting the 4 x mounting studs
through the corresponding holes in the back box.
Reach through the back door and secure with the nuts provided.
1.0
Front
Flange
Bottom
Mounting
Stud
Centre
Mounting
Stud
Top
Mounting
Stud
Firstly, remove the front panel by unscrewing the 6 x mounting nuts
2. Open the rear door and unscrew the 4 x mounting nuts
3. Reach through the front parcel door and unscrew the 2 x top mounting nuts
4. Gently pull the front panel to remove it from the back box
1. Open the front parcel door
Removing the Front Panel for Installation
Front
Parcel
Door
