2
SAFETY PRECAUTIONS
IMPORTANT—READ CAREFULLY BEFORE BEGINNING INSTALATION
•
Read this instruction manual completely prior to installation.
•
Installation should be performed by a professional installer.
•
If welding is required, it should be performed by a qualified welder.
•
Should electricity be required, use a certified electrician.
•
Use UL Listed wiring with an insulation rating of at least 600 volts.
•
Avoid splices in wiring. Solder and seal any splices in watertight junction box.
•
Always disconnect power before servicing the unit.
•
Be sure that all wiring to the unit is designed for direct underground burial.
•
Do not run power wiring greater than 200 feet.
•
Do not use onboard keypad power supply for anything other than the supplied transmitter. Locks, Loops,
Strikes, and other devices must have their own power supply, or must use the power supply of the gate op-
erator or garage door operator.
•
Do not position this keypad within 5 feet of any moving parts of a vehicular gate operator. The user of the
keypad should never be in an area that allows a vehicular gate operator to come in contact with the user
while the keypad is being operated.
HINTS
1. Programming and set-up of the 950/951 keypad is accomplished via the keypad face and through the
dip-switches located on the keypad circuit board.
Refer to page 6 for a description/explanation on programming through the keypad face.
Refer to page 7 for a description/explanation on dip-switch settings.
2. The 950/951 keypad provides both audio tones and led indicators during programming and normal use.
Refer to page 5 for a description/explanation of these tones and indicators.
‘*’
&
‘#’ Keys
‘*’
key is used to clear entries in progress.
‘#’
key is used as ‘Enter’ key function and to Exit Programming Mode
