5
PROGRAMMING SUB-MODES
Access Code Entry
—Sub-Mode 1
Sub-Mode 1 is for entering new access codes. The Model 950 keypad will hold 1000 4 digit codes.
4 digit code range is ‘0001’ to ‘9991’
Access Code Removal
—Sub-Mode 2
Sub-Mode 2 is used to delete individual 4 digit access codes from the keypad memory.
Flash Code Entry
—Sub-Mode 3
Sub-Mode 3 is used to enter a Flash Code into the keypad memory. The Flash Code will be deleted from the
keypad memory after it is used once. The purpose of a Flash Code is so that the homeowner can enter a 1 time
use code that will give a delivery or maintenance person access to the property. If the delivery/maintenance
person returns at a later time without homeowner approval, the code will already have been removed and
access will be denied.
Latch Code Entry
—Sub-Mode 4
Sub-Mode 4 is used for entering a single Latch Code into the keypad memory. The Latch Code can be entered
by the homeowner to hold the gate open. The gate will remain open until the Latch Code is re-entered. The
Latch Code is primarily used when a large number of vehicles need access to the property in a short amount of
time. The homeowner can give guests access without giving away access codes. The red and green LED’s on
the front of the keypad will flash while the keypad is in Latch Mode.
Latch Code is not used with the
Model 951 wireless keypad.
Relay Output Time
—Sub-Mode 5
The Relay Output Time is adjustable from ½ to 60 seconds. The Relay Output Time is used to increase the
time that the relay makes contact. This is useful when using the keypad with door strikes, etc.
Change Master Code
—Sub-Mode 7
By entering the current Master Code and accessing Sub-Mode 7, you can change the master code. Refer to
page 6 to see how to reset the Master Code if the current master code is lost or forgotten.
Clear All Access, Latch and Flash Codes
—Sub-Mode 8
All of the codes that are used to gain access to the property can be erased at one time by using Sub-Mode 8.
Note: Removal of codes can not be undone.
Once you have entered Programming Mode, you can access any of the Sub-Modes listed above by entering the
Sub-Mode Number followed by the # key. *******
KEYPAD PROGRAMMING & USE RESPONSE
Positive Feedback—Keypad will beep three times and the green led will flash five times.
NegativeFeedback—Keypad will beep ten times and the red led will flash five times.
Programming Feedback—Keypad will beep once every three seconds.
