5082019
23
OL’MAN OL-22-00 DOUBLE LADDERSTAND LADDER ASSEMBLY
There are four (4) ladder sections, one (1) top section, two (2) middle sections (which are identical) and one (1) bottom section. The
ladder also uses a bridge support in the rear of the ladder and there are four parts associated with it. NOTE: There are drain holes under
the end of each step. Make certain these are positioned to the bottom to preclude water from accumulating.
Figure 34
Ladder Assembly
STEP 1: Assemble the ladder by attaching the bottom section and one (1) middle section together using four (4) ladder connectors and
four (4) 5/16” x 2” bolts, eight (8) washers and four (4) nuts as shown in Figure 34. Place one (1) washer under the head of the bolts and
one (1) washer under the nuts. After all four (4) of the bolts are inserted you can tighten the four (4) nuts.
STEP 2: Now attach the second middle ladder section to the top of the other section. Only install the bottom two bolts at this time as
the top bolts are longer to attach the bridge support U brace, use two (2) 5/16” x 2-3/4” bolts. Place one (1) washer under the head of
all the bolts and one (1) washer under the nuts as shown in Figure 34.
STEP 3: Now tighten all the nuts. Next attach the top ladder section using four (4) ladder connectors, four (4) 5/16” x 2” bolts, eight (8)
washers and four (4) nuts as shown in Figure 34. Now tighten all the nuts. Next, attach the top four (4)ladder connectors to the top of
the ladder as they will be used to connect the ladder to the stand. Leave these bolts loose until time to attach the ladder to the stand.
Figure 35
Ladder Bridge Support Assembly
STEP 4: Assemble the three (3) parts of the ladder bridge support to together with two (2) ¼” x 1-1/2” bolts, four (4) washers and two
(2) nuts as shown in Figure 35.
