WIRING THE LP-1S
WIRING THE LP-1S
WIRING THE LP-1S
WIRING THE LP-1S
WIRING THE LP-1S
100
PHASE
10391 Jefferson Blvd, Culver City, CA 90232 310/204-2854
MILLER & KREISEL SOUND CORPORATION
RIGHT
RIGHT
FROM PREAMP
BASS LEVEL
LOW PASS FILTER
(Hz)
FROM AMPLI
FIER
MAX
50
75
60
125
Made in U.S.A.
T
4 AMP
120 VAC 50/60 Hz
TO SPEAKERS
LEFT
RIGHT
LE
FT
MIN
LEFT/MONO
SLOW-BLOW
ATTENTION:
DEBRANCHER AVANT DE
REMPLACER LE FUSIBLE.
UTILIZER UN FUSIBLE
DE RECHANGE DE MEME TYPE.
CAUTION:
DISCONNECT SUPPLY CORD
BEFORE CHANGING FUSE.
REPLACE FUSE ONLY
WITH SAME TYPE.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
AVIS:
RISQUE DE CHOC ELECTRIQUE. NE PAS OUVRIR.
+
RIGHT
LEFT
PREAMP
R
L
LP-1S
R
L
R
L
R
L
BASS OUTPUT TREBLE OUTPUT
INPUT
SPECIAL
MAIN OUTPUT
RIGHT
LEFT
POWER AMP
INPUT
FINAL ADJUSTMENT OF YOUR SYSTEM
FINAL ADJUSTMENT OF YOUR SYSTEM
FINAL ADJUSTMENT OF YOUR SYSTEM
FINAL ADJUSTMENT OF YOUR SYSTEM
FINAL ADJUSTMENT OF YOUR SYSTEM
Final adjustment is a matter of setting the Subwoofer’s BASS LEVEL control so that both bass and treble
levels are balanced. The best method is to set the level by ear — and when your system sounds balanced
to fit your room and personal preferences, it is correct. In a few minutes, listening to familiar recordings,
you will be able to set the balance of your system so that it is very nearly perfect. If you pay close attention
in further listening sessions, making fine adjustments when you feel they are appropriate, you will soon have
the precise balance you want. Time spent experimenting is well invested in the achievement of an ideally
balanced system. See your Subwoofer owner's manual for more detailed information.
SETTING THE FILTER ADJUSTMENT ON YOUR SUBWOOFER
SETTING THE FILTER ADJUSTMENT ON YOUR SUBWOOFER
SETTING THE FILTER ADJUSTMENT ON YOUR SUBWOOFER
SETTING THE FILTER ADJUSTMENT ON YOUR SUBWOOFER
SETTING THE FILTER ADJUSTMENT ON YOUR SUBWOOFER
When using the LP-1S, setting the FILTER adjustment on the back of your Subwoofer is very important.
As you adjust the BASS LEVEL control to match the Subwoofer and Satellite speakers, you also adjust the
FILTER control to match the speakers. The FILTER control will probably give you the best results when
set between 70 and 90 Hz. If you are not interested in experimenting, set the control at 85 Hz. Again, see
your Subwoofer owner's manual.
As you did above, listen carefully and make adjustments when they seem necessary. Set the FILTER
adjustment to the point where you hear a seamless blend between the Satellite speakers and the
Subwoofer.
If you have any further questions about the use of your LP-1S, please call us for additional help.
REV 11294LP1SMAN.PM5
