Miller Electric RCT-224 Trailer, Owner'S Manual

OM-6611 Page 9

3-5. Installing Taillight And Sidelight Wiring

802 814

Tools Needed:

Y

Support trailer with jack. Block

wheels.

1

Wiring Clips

2

Grommet

Locate wiring harness (packaged with tail-

lights).
Route wiring harness leads through trailer

frame and out hole near axle. Slide grommet

over leads and install grommet in hole.
Route brown and green leads along axle to-

ward right wheel and  brown and yellow leads

along axle to left wheel. Secure wiring to axle

with supplied cable ties.

Cut 45 in (1143 mm) from brown, green, and

yellow leads. Save cutoff wiring for connect-

ing side lights. Install taillights and sidelights

according to Section 3-10.

To install sidelight wiring:

 Use 45 in (1143

mm) wiring saved from taillight wiring to wire

sidelights. Separate brown leads from green

and yellow leads. Discard green and yellow

leads.
Splice sidelight short leads to wiring harness

brown leads using supplied tab connector

(see Section 3-6). Route brown leads along

top of frame and along back of crossmember.

Secure leads with wiring clips and cable ties.
Install wiring for other sidelight the same way.
Install sleeving on taillight and harness plug

electrical leads.

Brown

Lead

Brown And

Green Leads

Brown And

Yellow Leads

Use tab connectors to

splice sidelight brown

leads to taillight brown

leads. Tuck connector

through hole in frame.

1

Slide clips on frame

to secure wiring.

Brown

Lead

2