58
Hand Rinse Gun for Chemical Inductor (Optional)
The chemical inductor is supplied with a hand gun with approximately 5 feet of hose to rinse the
chemical inductor tank.
There are two ways the hand gun can be supplied with water:
•
Standard system via the product pump
•
Optional electric system via a 12 volt electric pump
Standard System
•
The standard system supplies water from the sprayer tank via the product pump and has an
ON/OFF valve located at the top of the control center. The control center is located at the front
of the sprayer.
•
The water supplied will be contaminated with diluted mixed chemical.
To Operate:
1.
Start the product pump. Be certain to have water in the product tank and the emergency shut
off valve under the product tank is open.
2.
Open the ON/OFF valve located at the top of the control center.
3.
Remove the hand gun from the storage bracket and rinse the chemical inductor tank.
4.
When finished close the ON/OFF valve, point the hand gun into the chemical inductor tank and
squeeze the trigger to drain the pressure from the hand gun and hose.
5.
Replace the hand gun to the storage bracket and replace the lid on the chemical inductor tank.
Summary of Contents for 500 BW
