65
Fill as follows:
1.
Connect the fill hose to the 2” connector.
2.
Open the water supply valve to fill the hose.
IMPORTANT: The water source MUST be higher than the sprayer pump. NEVER run the
sprayer pump dry. The sprayer pump will not draw water from a source lower than the
pump, until the pump is primed.
3.
Located under the operator platform on the left side of the sprayer is an electric 3 way ball
valve. Directly behind this valve is a manual ON/OFF valve with a yellow handle. Turn this
valve “OFF” (handle pointed toward rear of sprayer).
4.
Open the “Fast Fill” valve marked as “Valve F.”
5.
Start the product pump and run at full capacity.
6.
Slowly open the “Rinse Tank” valve marked as “Valve A” located on the front control stand
and let run until the rinse tank is full. Turn off the “Rinse Tank Fill” valve. There is a breather
hose on the rinse tank to allow air to escape.
7.
Stop the product pump.
8.
Close the “Fast Fill” valve.
9.
Turn the valve under the platform “ON” (handle pointed toward right side of sprayer).
10.
Shut off the external water source.
11.
Disconnect the fill hose and replace the dust cap. Be careful removing the fill hose from the
connector - there could be some liquid in the line.
Valve A
Yellow
Handle
Electric 3 Way
Ball Valve
Summary of Contents for 500 BW
