67
Long Term Shutdown
Rinsing the Product Pump, Product Tank, Controls and Boom Lines:
NOTE:
It is important to “Triple” rinse the system to insure proper cleaning. The use of a Neutralizer
is recommended for cleaning when changing chemicals.
Part no. 07.06876 Neutralize Liquid (1 gallon) or Part No. 07.06877 Neutralize Dry (2 lb. jar) are
available from your Miller dealer.
1.
Add the recommended amount of Neutralizer to the clean water rinse tank.
2.
Turn the manual 3 way ball valve identified as “Valve E” (located under platform on left side of
sprayer) to “Rinse Tank” (Point handle forward).
3.
Start the product pump and run at full speed.
4.
Open “Valve B” located in the front of the sprayer on the control stand. Let the pump run until
you have used a third of the water in the clean water rinse tank.
5.
Close “Valve B” located in the front of the sprayer on the control stand.
6.
Turn the manual 3 way ball valve identified as “Valve E” (located under platform on left side of
sprayer) to “Product Tank” (Point handle toward rear of sprayer).
7.
Drive at normal speed, turn complete boom on and spray as normal until product tank is
empty.
8.
Repeat the cleaning procedure two more times to ensure proper cleaning.
Valve B
PRODUCT
TANK
OFF
ON
RINSE
TANK
E
F
OFF
Summary of Contents for 500 BW
