77
200 Hour Lubrication Interval
Wheel Bearings
Every 200 hours (or yearly), repack the wheel bearings using a good quality wheel bearing grease.
Maintenance
General
Repair or replace damaged or broken parts immediately.
Check all safety and operating decals. If any decals are illegible or missing, replace any decals
immediately. DO NOT operate sprayer with missing or damaged decals. Refer to the “Safety
Decal” section of this manual for all safety decal locations. Refer to your parts manual for all operat-
ing decals.
Fasteners
After the first hour of use, check all the fasteners and tighten any found to be loose. Thereafter,
check all fasteners periodically and tighten as required.
Tire Pressure
Check the tire pressure daily.
The recommended tire pressure is:
12.4-24 6 ply tires .............................. 24 psi
11.2-38 4 ply tires .............................. 18 psi
Filters
Remove and clean the water filters daily. Clean the filters on the optional foam marking system at
intervals as specified in the foam system owner’s manual.
IMPORTANT: Always wear gloves and eye protection while servicing the sprayer.
To manually clean the self cleaning filter:
1.
Make sure the product pump is turned OFF.
2.
Close the emergency shut off valve under the product tank.
3.
Make sure the agitation valve and self cleaning filter bypass agitation valve are both closed.
4.
Place a clean empty container under the filter base to catch any water and chemicals.
5.
Very carefully disconnect the bypass line from the bottom of the filter and allow the water and
chemicals to flow into the container.
6.
Remove the canister from the filter head by rotating counter clockwise.
7.
Rinse the canister and screen in clean water.
Summary of Contents for 500 BW
