B
B
1 - 7
•
Naphtha and Methyl Ethyl Ketone (MEK) are flammable materials and must be used with caution. Follow the
manufacturer instructions to provide complete safety when using these materials. KEEP OUT OF REACH OF
CHILDREN.
•
To avoid burns, be alert for hot parts on products that have just been turned OFF and hot fluids in lines, tubes,
and components.
•
Always use tools that are in good condition. Make sure you understand how to use them before performing any
service work. Use ONLY genuine OEM replacement parts.
•
Always use the same fastener part number (or equivalent) when replacing fasteners. Do not use a fastener of
lesser quality if replacements are necessary.
•
Some state and federal agencies in the United States of America have determined that used engine oil can be
carcinogenic and can cause reproductive toxicity. Avoid inhalation of vapors, ingestion, and prolonged contact
with used engine oil.
Wheels and Tires Safety Precautions
For Your Safety:
•
I
f a rim is leaking air,
DO NOT
weld on the rim!
NO WELDING SHOULD BE DONE without prior authoriza-
tion from Miller-St. Nazianz. DO NOT
put a tube in the tire!
DO NOT
use tire sealant in the tire! These types of
repairs can allow the defect to propagate to the point that the rim could fail resulting in personal injury or severe
damage to the sprayer.
REPLACE
any leaking or damaged wheels with
NEW
wheels.
•
Never rework, weld, heat, or braze rims.
NO WELDING SHOULD BE DONE without prior authorization from
Miller-St. Nazianz.
If you have a wheel on your sprayer with a rim leaking air, contact your Miller dealer imme-
diately.
•
DO NOT
drive or load tires beyond their rated speed and load capacities. Check with the tire manufacturer for
load and speed ratings for your particular tire.
•
Driving this vehicle with product in the product tank at high speeds on public roads will lead to tire fail-
ure resulting in loss of vehicle control. Always empty the product tank before leaving the area of opera-
tion.
Electrical Safety Precautions
OPERATION OF ELECTRICAL COMPONENTS
For Your Safety:
•
This machine and its systems are designed to operate using a 12-volt DC power supply only.
•
Never operate this machine with a damaged electrical cord. Disconnect from electrical supply if machine is not
working properly or cord is damaged.
•
Do not attempt to operate this machine without the appropriate fuses and breakers in place.
•
Do not attempt to bypass a fuse. If a fuse is no longer serviceable, a shock or short hazard may exist.
•
Never replace original fuses/breakers with a higher amperage fuses/breakers.
•
Inspect all components for damage after any electrical problem.
•
All electrical components generate heat. To avoid serious burns, never touch internal components immediately
after use.
•
Disassembly or attempted repairs, if accomplished incorrectly, can create electrical shock and/or short hazards.
Only qualified personnel should perform repair service.
