1 - 8
•
Never attempt to replace electrical wires and cables with smaller gauge wire and cable.
•
Some electrical components can store energy after the unit is shut down. Be sure to completely de-energize all
electrical components, discharging all stored energy before beginning any service work.
Towing Safety Precautions
IMPORTANT
: Contact your MIller dealer for more information on proper towing procedure. Failure to do so may cause
severe damage to the drive system.
If the vehicle must be towed and the vehicle has lost engine and/or hydraulic system power, the parking brakes will
automatically apply. The parking brake is spring-applied when hydraulic pressure is lost. Contact your dealer for prop-
er procedure to disable the parking brake. Tow the vehicle at very slow speeds and only for a very short distance. Fol-
lowing are the steps to towing a downed vehicle.
Moving a Downed Vehicle
1.
Obtain the Miller kit Part Number 21.25539, or have available the two O-ring face seal Run Tees and Port-A-Power
adapter included in the kit. Fill the Port-A-Power with clean, 68 weight hydraulic oil only to prevent contamination of
the hydraulic system. Add additional oil as needed to maintain pressure.
Brake Over Under (BOU) Block
2.
Locate the Brake Over Under (BOU) block, located in front of the ladder.
&(
)&
