Milliard Brands © 2018 All Rights Reserved.
6)
With the beam upside-down, slip the lower leg assemblies over the upper leg assemblies on the beam
and make sure that the ports for the height adjustments are turned outward. Then, screw in the height
adjustment knobs (
D
) on each support until you feel gentle tension. Do not tighten them all the way.
7)
Pull on the lower l
eg support on each side until you hear an audible “click”
and the leg stops moving. Now
you may tighten the height adjustment knob fully and the beam should be locked in position. You may
now flip the beam over and enjoy.
8)
To adjust the height on the beam again, loosen the height adjustment knob just enough to release tension
and then pull on it to release the
locking spring. Pull the beam up or down until it’s at your desired height
and then release the knob and let it click into place, then tighten it down to lock it again. Repeat for each
side.
DISCLAIMER:
Milliard™ assumes no liability or responsibility for accidents or injuries to persons or properties associated with the impro
per use of this product, nor does Milliard condone
prohibited or unlawful uses. This product must be used as directed and all safety precautions must be followed at all times in accordance to federal and local laws or regulations. Buyer assumes
all risks and liability from misuse of this product and Milliard shall not be held liable beyond the initial purchase cost of the product for any damages arising from its misuse.
Figure 2