Chapter 3. Routine Maintenance
PELLERIN MILNOR CORPORATION
Table 6: Bearings and Bushings. See
Table 7
for Motors.
Apply grease to these components to prevent damage.
Mark
1
2
3
4
5
6
Do this each
Component
More Data. See also
Section 3.1.4
“Lubricant Identification and Procedures”
x
200 hours
top and bottom ball bushings,
each Hydrocushion
See
Figure 20
. See also
Figure 16
. Add 0.12
oz (3.6 mL) of grease EPLF2 (
Table 10
)
See
Figure 16
for these drive maintenance items. All items take grease EPLF2 (
Table 10
).
x
200 hours
drive bearings—two places
(front and rear)
Add 0.37 oz (11 mL)
x
200 hours
bearing seals—two places
(front and rear)
Add 0.12 oz (3.6 mL)
x
200 hours
jackshaft bearings (3 places)
Add 0.12 oz (3.6 mL)
x
200 hours
idler shaft bearings on Staph
Guard
®
models only—two
places
Add 0.31 oz (9.2 mL)
x
200 hours
bearing seal for disk brake
assembly on idler
shaft—60044SP2 and
72044SP2 only
Add 0.12 oz (3.6 mL)
x
200 hours
brake band bushings—two
places—60044WP2 and
72044WP2 only
Add 0.06 oz (1.8 mL)
See
Figure 17
for these door maintenance items. On Staph Guard
®
models, these items apply to soil
side and clean side doors.
x
200 hours
door hinge—60044SP2,
72044SP2 and 3-pocket
models
Add 0.12 oz (3.6 mL) of grease EPLF2
(
Table 10
).
none
door hinge—60044WP2 and
72044WP2 (Rapid Load
™
)
models
no door hinge grease maintenance necessary
x
200 hours
door latch plunger
Apply stick DE3 (
Table 10
) to surface.
Table 7: Motor Grease Schedule. Use the data in
Section 3.1.4.2
to complete this table.
Interval
Quantity
Dates When Grease is Added
Motor Identification
(example: main drive)
Years
Hours
fl oz
mL
.
25
Summary of Contents for 60 Series
