Pellerin Milnor Corporation
17
NOTICE:
You must load every pocket on your machine.
Continue to
Section 3.10 : Start the wash formula., page 18
3.9.2
To Load the Pocket(s) with a Separate Laundry Scale
BNWVUO05.T03 0000306859 E.3 C.2 B.4 10/15/20 4:49 PM Released
Use the following instructions to load the remaining pocket(s) if you have a divided-cylinder ma-
chine and your machine is not equipped with the optional weighing system (load cells). If your
machine is equipped with the optional weighing system (load cells), see
CAUTION:
Ensure the inner and outer doors are fully closed before you attempt to ro-
tate the cylinder.
1. Touch
on the
Home
screen. A dialogue box appears (shown in the following figure),
which prompts you to transfer control to the clean side or the soil side.
Figure 8.
Confirmation Dialogue Box
2. Touch the button labeled
Soil
. The basket rotates so that you can access the next pocket on
the soil side.
DANGER:
Contact with the turning cylinder —
can crush your limbs. The turn-
ing cylinder and goods are normally isolated by the locked cylinder
door.
�
Always close the inner and outer doors before you rotate the
cylinder.
�
Do not attempt to open the door or reach into the cylinder while it
rotates.
�
Do not operate the machine with malfunctioning two-hand manual controls.
3. Open the outer door.
4. Open the inner door.
5. Load the second pocket.
6. Close the inner door.
7. Close the outer door.
8. If your machine is a three-pocket machine, repeat steps 1–7 to load the third pocket.
Summary of Contents for MilTouch MWB26Z
Page 2: ......