22
Pellerin Milnor Corporation
3.11.1.2.1
How to Monitor Automatic Liquid-Chemical Injections
BNCLJO11.C04 0000214843 E.3 C.5 C.2 9/11/20 10:33 AM Released
Figure 13.
Chemicals from Valves 1 and 2
Injecting
If your machine controls a pumped chemical sys-
tem, the controller automatically injects chemi-
cals from the pump system while the formula
runs.
You can monitor automatic liquid-chemical in-
jections in the
Machine Status
area. As the con-
troller injects a chemical into the machine, the
chemical’s valve number illuminates, as shown
in
, until the programmed injection
time expires.
3.11.1.3
Manual Control and Diagnostics Area (C)
BNCLJO11.C03 0000213316 E.3 C.5 C.3 9/11/20 10:35 AM Released
Use these buttons as explained in the following figure.
Figure 14.
Standard Controls
Legend
C. Cancel the formula (see
M. Actuate manual controls (
D. Run diagnostics (see reference manual)
3.11.2
Respond to the end of the cycle.
BNWBUO02.T01 0000279617 E.3 C.5 A.7 9/11/20 10:37 AM Released
The operator signal will sound when the cycle ends.
BNWBUO04 / 2020403
BNWBUO04
0000279926
A.12
9/29/20 10:03 AM
Released
3.12
Unload the machine.
BNCLKO05.T02 0000254489 E.3 A.12 C.5 9/9/20 4:39 PM Released
While the clean-side buzzer sounds, the cylinder automatically turns to the clean-side position
(the discharge position). The green clean-side light
illuminates to indicate the outer door on
the clean side is unlocked and the machine is ready to discharge goods.
NOTE:
If the cylinder does not turn to the clean-side position, or if the inner (cylinder)
door and outer (shell) door are misaligned, press the
Reposition
button (
). The cylin-
der rotates to the clean-side position, or rotates to the next pocket on the clean side if the
cylinder is already on the clean side.
1. Open the outer door on the clean side.
2. Open the inner door.
3. Unload the goods from the cylinder, or unload the goods from the pocket if your machine is a
divided-cylinder machine.
4. Close the inner door.
Summary of Contents for MilTouch MWB26Z
Page 2: ......