Sterylis VS Manual
| 20
During the standard disinfection mode, the device indicates:
- Characters - - - - on the display in the O
3
STERILIZATION section or the LOCH message (when the device is in locked
mode) and error and message codes (if any)
- On the display in the O
3
CONCENTRATION section: Value of the current ozone concentration when the concentration
exceeds 0.1 ppm / Characters - -.- - during the ozone sensor warm-up phase / In other cases, the display is inactive
- Characters - - : - - on the display in the OZONING TIME section
The standard mode can also be directly selected if the unit is in silent disinfection or filtration mode. To switch from silent
disinfection or filtration mode to standard disinfection mode, press and hold the START button located at the green
standard mode light.
To interrupt the standard disinfection process, press and hold the START button next to the green standard mode light
again.
6.3.3 “UV-C air disinfection – silent mode” operating mode
To start the "UV-C air disinfection - silent mode" operating mode, press and hold the START button located at the green
silent mode light. The silent mode light will start blinking with low frequency (the device will check the proper functioning
of the relevant actuators - PRE-TEST function) and then it will start to light steadily and the device will start working in
the selected mode of operation. Confirmation of the disinfection mode is the operation of the front panel illuminated on
the unit. If any errors are detected during the test, the device will display a tESt message, enter the standby mode and
then display the corresponding error codes on the display in the O
3
STERILIZATION section (except for errors F201 and
F202, which cause the PRE-TEST to stop until the error is corrected - the filter cartridge is inserted)
During the silent disinfection mode, the device indicates:
- Characters - - - - on the display in the O
3
STERILIZATION section or the LOCH message (when the device is in locked
mode) and error and message codes (if any)
- On the display in the O
3
CONCENTRATION section: Value of the current ozone concentration when the concentration
exceeds 0.1 ppm / Characters - -.- - during the ozone sensor warm-up phase / In other cases, the display is inactive
- Characters - - : - - on the display in the OZONING TIME section
The silent mode can also be directly selected if the unit is in standard disinfection or filtration mode. To switch from
standard disinfection or filtration mode to silent disinfection mode, press and hold the START button located at the green
silent mode light.
To interrupt the silent disinfection process, press and hold the START button next to the green silent mode light again.
