SCROLL 15SP1CB / 13SP2CB – 35SP1CB / 29SP2CB – 52SP1CB / 42SP2CB
10
520606-00
EN
④
Install back-up tube and face seal
Move the seam of each seal 180 degrees.
2)
Assembly of the fixed scroll
①
Assemble the fixed scroll on the basis of 2 places knock-pin.
Note for the direction of the fixed scroll.
②
The gap of the fixed scroll and frange surface of casing should be below 2 mm.
If the gap between the fixed scroll and the casing is more than 2mm or is not parallel, there is a possibility that the tip seals or
face seal are not installed in the groove properly.
In this case, never tighten nuts and disassemble the fixed scroll and repeat the same
process to install the tip seals or seal properly.
③
Tighten 4 of M10 nuts including washers.
First tighten nuts by hand and then tighten them at the equal torque of 30 N-m using a torque wrench.
Summary of Contents for 13SP2CB
Page 16: ...www mils fr...
