The instrument housing is designed to lower the risk of electric shock, short, and spread of fire.
Except for the
front access covers, do not remove or penetrate any cover, nor any cover of other accessory
hardware supplied by Miltenyi Biotec. Only authorized personnel is allowed to remove any
other cover of the instrument. Never push an foreign object through an opening into the
instrument.
Do not use the instrument if
l
it has been opened or disassembled
l
it has been dropped or damaged
l
it has damaged or broken parts
l
it has a damaged power cable
l
an object has entered through the ventilation slots
l
an object has been dropped into the instrument
The instrument is intended for indoor use only. If liquids enter the instrument, it may lead to electric shorts,
shock, or fire. Take special care while handling liquids.
Do not allow liquids to enter the interior of the instrument. Protect the instrument against
accidental spillages and splashes. Clean up spillages immediately. Do not operate the
instrument if liquids have entered the instrument.
Do not use the instrument in a wet and damp
location. Avoid areas with high humidity or condensation. Moving the instrument from a cold environment –
such as a cold room at 5°C – to room temperature may cause condensation inside the instrument. In such
cases, wait for the instrument to dehumidify before operating it.
Before cleaning, unplug the instrument. Do not use liquid or aerosol cleaning agents, always use a damp cloth.
Protect the instrument from overheating. Do not use the instrument in areas with more than 25°C. Ensure
adequate air circulation in the room when the instrument is operated. Allow sufficient air circulation around the
instrument – at least 15 cm on all sides – during operation.
Do not place the instrument near radiators,
heat registers, stoves, or other equipment (including amplifiers) that generate heat. Protect the
instrument from direct sunlight. Do not cover the slots and openings of the instrument as
these are provided for ventilation.
Do not place the instrument in a built-in rack or similar confined
spaces unless the space has been specifically designed to provide proper ventilation. Follow the mounting
instructions for the instrument.
The instrument is equipped with a three-wire electrical grounding-type plug that has a third pin for grounding.
This plug fits in a grounded power outlet only. This is a safety feature.
Do not try to insert the plug into a
non-grounded power outlet.
If you cannot insert the plug into the outlet, contact your local electrician to
replace the outlet.
Only peripheral devices that comply to UL 60950 are allowed to be connected to the RS232 connector labeled
COM1.Only original MACSQuant Instrument equipment should be attached to the connectors labeled External
CAN.
Only the 2D code reader that was delivered with the instrument should be connected to to the RS232/BCR port.
External laser devices connected to to the RS232/BCR port have to comply with the standard IEC 60825-1.
11
IM
P
O
R
T
A
N
T
S
A
FE
T
Y
IN
FO
R
M
A
T
IO
N
E
N
D
E
E
S
F
R
IT
Summary of Contents for MACSQuant 10
