2
IN
S
T
A
LL
A
T
IO
N
63
2.5
Assembly
2.5.1
Install the fluid bottles
Operating the instrument requires Running Buffer, Washing Solution, and Storage Solution. One bottle is
required for waste collection. Always operate the instrument with ready-to-use MACS® Buffers and solutions
only. The bottles, closures, tubing and fluid sensor cables are color-coded for easier handling.
1
Install only one fluid bottle at a time. Place the new bottle into the orange bottle holder. Please note the
corresponding color coding.
2
Unscrew the lid of the fluid bottle and replace it with the appropriate bottle closure delivered with the
instrument.
3
Remove the caps from the bottle distribution block and connect the tubing to the appropriate color-coded
fluid port of the bottle distribution block on the back of the instrument (refer to
).
Figure 2.1:
B
Connect Waste and Storage Solution bottle.
Summary of Contents for MACSQuant 10
