i
IMPORTANT SAFETY INSTRUCTIONS
WARNING
WHEN INSTALLING, CALIBRATING, OR OPERATING THIS ACTUATOR, BASIC
SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED TO REDU CE RISK
OF FIRE, ELECTRIC SHOCK, AND PERSONAL INJUR Y. FAILURE TO FOLLOW
THESE INSTRUCTIONS COULD RESULT IN DEATH OR SERIOUS INJURY.
Read all instructions before installation, calibration, or operation
GENERAL SAFETY CONSIDERATIONS
- Read this manual carefully.
- Installation, calibration, and maintenance should be performed by trained and qualified personnel. Per-
sonnel should be familiar with the precautions required in working with hazardous voltages which exist
inside the actuator. Personnel should also be adequately trained on any hazards inherent in the chem-
icals used in the metering pump.
- Always wear protective clothing including gloves and safety glasses when working on or near chemical
metering pumps.
- Follow directions and warnings pr ovided with the chemicals from the chemical manufacturer. User is
responsible for determining the hazards associated with the chemicals being pumped and using the
proper safety gear and procedures.
- Hazardous voltages are present when cover is removed. Disconnect power when installing or servicing
this unit.
- Unit must be properly grounded.
- Conform to local codes in wiring this equipment.
- Actuator must be adequately rated if it is to be used in a hazardous location. See product data plate for
rating information. This ratin g must not be exceeded under any circumstances. To prevent ignition of
hazardous atmospheres, cover must be tight while circuits are energized.
- In order to comply with the requirements of agency approvals (see data plate), specifications for con-
duit conn ections, wire ga uge a nd type, fastener to rque r atings, a nd operating co nditions must b e
adhered to.
www.motralec.com / service-commercial@motralec.com / 01.39.97.65.10