41 |
P a g e
Version 2.1 (10/2020) EN
User Manual for SEIT 1500
•
Setting Up The Charger
After MR AutoC
–
15
00’s setup is prepared, one must follow the following procedures to initialize
the docking station.
➢
Plug connection cable’s one end into “
(See page 33)
and plug the other
end into the 110/220V AC grid. (
See Figure 5.19 for connection cable
)
➢
Turn “
(See page 33)
in CW direction to initialize MR AutoC
–
1500.
➢
(See page 33)
of MR AutoC
–
1500 starts to show sliding effect in white color,
which means it is booting.
➢
When led indicator turns solid white, it is ready to charge SEIT 1500.
By turning “
(See page 33)
in CCW direction, one may turn off the docking station.
DANGER
Risk of injury
ELECTRICAL SHOCK HAZARD. DO NOT TOUCH BOTH PINS WHILE ENERGIZED.
•
Charging Manually
Either SEIT 1500
’s battery is charged man
ually via charging pads or directly via anderson battery
connector.
To charge via anderson battery connector, one must follow the following procedure;
➢
Plug the connection cable’s one end into “
(See page 33)
and plug the other end into “
(See page 24). (See Figure 5.18
for supplied connection cable).
To charge via charging pads, one must “
” and draw it up to MR
AutoC
–
1500 as in the
Figure 5.17. (See page 28 to check manual drive).
•
Charging Automatically
To charge automatically, please refer to software interface part on this manual.
