4
Installing/Removing the Accessories
To
install
the nozzles, line up the tabs on the nozzle
with the notches on the tube. Slide the nozzle onto
the tube until it snaps in place. Pull on the nozzle to
ensure it is secure. To remove, press the tabs in and
pull away from the tool.
Fuel Gauge
Use the Fuel Gauge to determine the lowest battery
pack's remaining run time. When less than 10% of
charge is left, 1 light on the fuel gauge will flash 4
times. When the battery reaches 0% charge, 1 light
on the fuel gauge will flash 8 times. Charge the bat
-
tery packs.
If the Fuel Gauge doesn't appear to be working,
place the battery pack on the charger and charge
as needed.
Immediately after using the battery pack, the Fuel
Gauge may display a lower charge than it will if
checked a few minutes later. The battery cells "re-
cover" some of their charge after resting.
Fuel Gauge
Lights
Diagnosis
Solution
Lights 1 - 4
Solid
Remaining
run time
Continue working
1 Light,
flashing slowly
Less than
10% run time
left
Prepare to charge
pack
1 Light,
flashing quickly
End of
discharge
Charge pack
SPECIFICATIONS
Cat. No. ..................................................... 2824-20
Volts.............................................................. 36 DC
Battery Type .................................................
M18™
Charger Type................................................
M18™
No Load RPM ...............................................16,750
Air speed (CFM) .......................................... 0 - 600
50' Bystander Sound Pressure Level ....... 64 dB(A)
Recommended Ambient
Operating Temperature .................... 0°F to 125°F
ASSEMBLY
WARNING
Recharge only with the
charger specified for
the battery. For specific charging instructions,
read the operator’s manual supplied with your
charger and battery.
Removing/Inserting the Battery
To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
WARNING
Always remove the bat
-
tery packs any time the
tool is not in use.
To insert the batteries, slide the packs into the body of
the blower. Make sure they latch securely into place.
NOTICE
The blower requires two charged
battery packs to operate.
•The blower will not work with only one battery pack.
•If one battery pack is completely discharged, the
blower will not function, even if the second battery
pack is charged.
•For best results, use with (2) MILWAUKEE HIGH
OUTPUT™ HD8.0 or higher capacity battery packs.
WARNING
Only use accessories
specifically recom-
mended for this tool. Others may be hazardous.
Tube Assembly
WARNING
To reduce the risk of
injury, do not operate
blower without tube securely in place. Never
reach into blower through tube hole.
To
install
, line up the tab on the tube
with the notch in the housing. Slide the
tube into the housing until it snaps in
place. Pull on the tube to ensure it is
secure.
To
remove
the tube for storage, press
the tube latch and pull the tube out of
the housing. Always re-install the tube
before use.
