6
7
FUNCTIONAL DESCRIPTION
5
4
3
2
1. Workpiece
contact
2. Nail
guide
3. Exhaust
defl ector
4. Actuation
selector
5. Trigger
1
ASSEMBLY
Exhaust
The exhaust cap can be adjusted to direct
the exhaust as desired. Turn the exhaust cap
to the desired locking position.
Lubricating the Tool
Lubricate the tool with air tool lubricant
before connecting the air supply. Under low
use, lubricate once a day. Under heavy use,
lubricate twice a day. Use only a few drops
of oil at a time. Using too much oil will cause
it to collect in the tool and be noticeable
in the exhaust. Do not use detergent oil,
WD-40, transmission fl uid, motor oil, or other
lubricants not specifi cally designated as air
tool lubricant. These lubricants will cause
accelerated wear to the seals, o-rings and
bumpers in the tool, resulting in poor tool
performance and frequent maintenance.
2-3
drops of
air tool
lubricant
Fig. 1
3/8" NPT quick
connector
Adjusting/Removing Shingle Guide
To adjust the shingle guide, press in the
guide button and slide the guide to the de-
sired location. To remove the guide, press in
the guide button and slide it toward the nose
of the tool and off of the track.
10
8
6. Air
inlet
7. Magazine
cover
8. Depth of drive adjustment
9. Fastener door lever
10. Nameplate/Warning label (not shown)
11. Fastener door
9
7
11
Guide button
Fig. 2
6
WARNING
Disconnect the air supply from the
tool and remove fastener strips
before changing or removing acces-
sories. Only use accessories spe-
cifi cally recommended for this tool
by the manufacturer. Others may be
hazardous.
The operator and other people in the
work area must wear eye protection
in accordance with ANSI Z87.1. Eye
protection does not fi t all operators
in the same way. Make sure the eye
protection chosen has side shields or
provides protection from fl ying debris
both from the front and sides.
